Can the AGR hydraulic end for UHP carbon steel hose, type PBZ110 be used with other crimping sleeves than those specified for the hose?

No — the AGR hydraulic end for UHP carbon steel hose, type PBZ110 must be crimped only with the compatible crimping sleeve specified for that UHP thermoplastic hose. The fitting is engineered with a special tail and precise geometry for use with a sleeve tailored to the hose type to ensure correct compression, 60° cone sealing (AGR) integrity, and safe performance under ultra-high pressure. Using a different or non-specified sleeve can compromise seal tightness, mechanical retention and safety, increase risk of leaks or hose blow-off, and void any performance or warranty expectations. Always use the manufacturer-recommended sleeve and crimping procedure for PBZ110.

Is the AGR hydraulic end for UHP carbon steel hose, type PBZ110 compatible with thermoplastic hoses from other manufacturers?

The AGR hydraulic end for UHP carbon steel hose, type PBZ110 is specifically engineered for crimping with UHP thermoplastic hoses and features a special tail and a compatible crimping sleeve requirement. Compatibility with thermoplastic hoses from other manufacturers is possible only if those hoses have the exact same dimensions, material properties and are approved for use with the PBZ110’s required crimping sleeve and 60° cone (AGR) sealing geometry. Using hoses or sleeves not specified for PBZ110 risks improper crimping, seal failure under ultra-high pressure and loss of warranty or safety certification. To ensure safe compatibility, verify the other manufacturer’s hose specifications (outer/inner diameter, reinforcement, crimping sleeve type), confirm they are rated for the same UHP service, and obtain explicit approval from either your hose supplier or the PBZ110 manufacturer before assembly.

A fitting hydraulic AGR for hose UHP steel carbon, type PBZ110

Additional information

Material	CS – steel (cast iron)

A fitting hydraulic (type P – of special „tail” for hose thermoplastic) with thread external BSP, sealing on a 60° cone (AGR). Intended for crimping in hoses thermoplastic UHP using ferrule crimping, appropriate for type hose. Material: steel carbon, galvanized.

List of product variants

Article number	Product variant name	DN	BAR	Availability	Actions
TI-PBZ110-04-025-TO	Fitting 1/4" BSP male, hose thermoplastic 5/32", 60° AGR	4	800	In stock	Enquiry
TI-PBZ110-04-04-TO	Fitting 1/4" BSP male, hose thermoplastic 1/4", 60° AGR	6	800	In stock	Enquiry
TI-PBZ110-06-04-TO	Fitting 3/8" BSP male, hose thermoplastic 1/4", 60° AGR	6	800	In stock	Enquiry
TI-PBZ110-06-06-TO	Fitting 3/8" BSP male, hose thermoplastic 3/8", 60° AGR	10	800	In stock	Enquiry

Do you need a larger quantity of products or a bespoke quote?

Call us: +91 8 925 918 796 or email us: chennai@tubes-international.com

SEND ENQUIRY

A fitting hydraulic (type P – of special „tail” for hose thermoplastic) with thread external BSP, sealing on a 60° cone (AGR). Intended for crimping in hoses thermoplastic UHP using ferrule crimping, appropriate for type hose. Material: steel carbon, galvanized.