Hydraulic adaptors
Type of material:

High pressure adapters in carbon steel

High pressure adapters in stainless steel
List of products:

BSP adapters

NPT adapters

Metric adapters

SAE flange adapters

x
Skip to contentHydraulic adapters are used in high pressure hydraulic systems for connecting hydraulic flexible assemblies and tubes with other components of a system (pumps, valves, quick release couplings etc.). They enable changing the type of connection or reducing the size to suit the connections of the components to be joined. Made of zinc-plated carbon steel or AISI 316 stainless steel. They may come with elastomer seals, e.g. O-rings made of NBR rubber or Viton. They are designed for a typical working pressure range of high-pressure hydraulics (around 100 to 400 bar). They can be used at lower operating pressures, for general industrial applications and pneumatics.
When calculating the maximum working pressure of an adapter, the safety factor must be considered as a combination of both the pressure resistance of this adapter and the strength and tightness of the connection between the adapter and another component that is screwed to it. If there are different types and sizes of connections on either side, the working pressure of the adapter will be determined by the lower of these values.
The adapters are sealed while they are attached, usually using PTFE tape, bonded or copper seal, also on 60° cone.
Tubes International
No.4, 2nd floor, Plot no: 127,
Ramamoorthy 2nd main road,
Pazhanthandalam village, Thirumudivakkam,
Chennai – 600044, India
Phone: +91 8 925 918 796
Phone: +91 8 925 918 797
Copyright © Tubes International
Oops! We could not locate your form.
Oops! We could not locate your form.